Home | About Us | Products | Fabshop | Contact Us | News | Trade Shows Before You Buy |  Articles |  Suggestions
Refacing Tools (Drilco - Compatible)
Pin and Box Mandrel Sets (steel construction)
  • Type 1 Sizes: 2-3/8 to 2-7/8, all thread sizes (except 2-7/8 IF) – with built-in shaft
  • Type 1 Sizes: 2-7/8 IF to 5H90, all thread sizes (except 4-1/2 IF) No shaft
  • Type 4 Sizes: 4 1/2 IF to 6-5/8, all thread sizes 7-5/8 REG or H90;
    8- 85/8" REG or  H90

    Face Plates

    • Type 1 sizes, aluminum  
    • Type 4 sizes, aluminum
     
refacingtools.gif
Drive Tubes (assembled, lightweight aluminum construction)
• Type 1, with cap & bearing cartridge  
• Type 4, with cap & bearing cartridge
 

Mandrel Adapter Shafts  
• Shaft for Type 1 & 4 mandrels (standard length)  
• Shaft for longer length) to adapt 2-7/8”IF to 4-1/2REG mandrels to  Type 4 drive tube

  NOTE:
2-3/8”&2-7/8” AOH & PAC mandrels with built-in shafts will not work with a Type 4 drive tube

Supplies

• 6" adhesive refacing discs, each (Part #18728) 
• 8" adhesive refacing discs, each (Part #18729)  
• 11" adhesive refacing discs, each (Part #50346)  
• Milwaukee 7” angle grinder, 110V (Part #19061)  220 volts available
           

Spare Bolt Kit for Refacing Tools
(10 for faceplate, 6 for adapter shaft) Used refacing tools available when in stock.  Please inquire for prices

 

Home  |  About Us  |  Products  |  Fabshop  |  Contact Us  |  News  |  Trade Shows  |  Before You Buy  |  Articles  |  Suggestions
All Rights Reserved 2014 New Tech Systems